Information for Lanyard supplied by the manufacturer(Requirements of EN354-2010)
The information supplied by the manufacturer shall conform to EN 365 and, in addition, shall include at least advice or information as follows:
a) that the user should read and understand the information supplied by the manufacturer before using the lanyard;
b) that a lanyard shall not be used for fall arrest purposes without any energy absorption, e.g. an energy absorber;
c) that the total length of a lanyard connected to an energy absorber (including terminations and connectors) shall not exceed 2 m;
d) the material from which the lanyard is made;
e) the number of this European Standard, i.e. EN 354:2010;
f) that, if the risk assessment carried out before the start of work shows that loading in the case of a use over an edge is possible, appropriate precautions should be taken;
g) that the user should minimize the amount of slack in the lanyard near a fall hazard;
h) when adjusting the length of a lanyard to avoid the risk of fall, the user should not move into an area where there is a fall hazard;
i) the usable life of the product and recommendations/information where the life expectancy could be reduced;
j) information on whether the lanyard may be used choke hitched;
k) information on the allowed/disallowed arrangements/configuration of lanyards when combined with an energy absorber.
Non exhaustive examples are:
1) Two separate lanyards each with an energy absorber should not be used side by side (i.e. parallel);
2) The free tail of a twin tail lanyard combined with energy absorber should not be clipped back on the harness.







