TOHO Industrial Corp.

Safety Lanyard Installation And Removal

Dec 17, 2020

When disassembling the safety lanyard, if the hanging point has holes, the object and the shackle are connected with the sling ODO, and the shackle cross pin passes through the hanging hole to lock the lifting. The lifting point is reserved by the manufacturer for easy installation and disassembly. The rope is lifted from here, and the balance of the object is better.

If there is no hanging hole, when a rectangular box over 6 meters is removed, it will be blackmailed. The shackle at the lifting point is connected with the sling with Dq. After the safety lanyard wraps the object, it is connected with the shackle DI to tighten the object. When the object has sharp edges, remember to use wooden strips or rubber padding to protect ( Used tires are the most cost-effective spacers to prevent the safety lanyard from being cut. Tie a hanging point on each of the left and right three quarters, so that the balance point is relatively accurate after the object is lifted. Even if the lifting point is not accurate and the balance is not good, it will only shake twice and will not fall off, causing damage to the object.


goTop