The original seat belt fixing points on the car can be used. The proportional position of the seat belt fixing point.
The angle between the shoulder strap and the horizontal line of the shoulder of the seat should not be greater than 45 degrees, and the maximum angle with the center line of the seat is 20 degrees (dispersion or convergence). Use the original fixed points of the manufacturer as much as possible.
The seat belt shall not be installed on a seat without a headrest or on a seat with a non-adjustable headrest (no gap between the seat back and the headrest). If the shoulder straps are cross-fixed behind the seat, the shoulder straps must pass through both sides of the headrest column. Conversely, if the shoulder straps do not form a cross behind the seat, the shoulder straps must pass between the two pillars of the headrest.
If a bucket seat is used, the waist belt or hip belt should pass through the belt hole in the lower part of the seat and must not be used outside the edge of the seat to maximize the enclosure of the rider's pelvis. It must be noted that the waist or hip belt will not be damaged by friction when passing through the seat belt hole.
If it is impossible to install the shoulder belt on the original fixing point, the belt can be installed on an additional horizontal support bar and fixed by winding method or bolts. If fixed with bolts, the inserted part of the bolt body must be welded to the fixed point.
Where a new installation point is installed on the vehicle body, a reinforced steel plate must be used at this installation point, with an area of at least 40 square centimeters and a thickness of at least 3 mm.





